John Hackett

Veteran Advocate
Health Coach
Cancer Survivor

How I used the GB4000 to fight my Stage 4 Prostate Cancer

I used a carrier frequency of 3100000 with "audio" and "Square Wave". I also used 3215000 with the "RF" and "Sine Wave" program (113)


How I setup the MOPA.... from right to left....

  1. I set Frequency switch to "Set Frequency"
  2. I set Counter switch to "on"
  3. I set Power switch to "on"
  4. I set the plasma tube to where it will be for treatment and did not move it as it can change the frequency.
  5. Once the MOPA has stabilized (5 minutes)
  6. I moved Counter switch to "off"
  7. I set Frequency switch to "Run"
  8. I turned on the GB4000 Generator.
    (These are the initial steps I do every time I run the machine.)

How I set the GB4000 for infection

  1. I set it for "Audio" and "Square Wave"
  2. I use the default time (5 minutes) and the program will run for 25 minutes.
  3. I push "Auto Channel"
  4. I push "407" then push "Run"
  5. I adjust the power output knob on the GB4000 until MOPA milliamp meter reads about 200.

How I set up for Inflammation.

  1. I set the GB4000 for "Audio" and "Square Wave".
  2. I press "15" and the program will run for 30 minutes.
  3. I press "Auto Channel" then press "410" then press "Run".
  4. I adjust the power knob on the GB4000 until the MOPA reads about 200 milliamps.

How I set up for Immune system stimulation.

  1. I used "Audio" and "Square Wave".
  2. This is a G3 program so I press "10" to run for 30 minutes.
  3. I press "402" then press "Run"
  4. I adjust the power knob on the GB4000 until the MOPA reads about 200 on the milliamp meter.

How I set up for my Prostate Cancer.

  1. I set the Carrier frequency on the MOPA to 3215000.
  2. I set the GB4000 for "RF" and "Sine Wave".
  3. I press "Channel Sweep" then press "20000" then press "Enter".
  4. I press "60" (minutes) this will run the program two hours.
    Note# When first starting out I run this 5 minute and see if I get a reaction. If I get a reaction, I don't increase the time, I move the plasma tube further away from the body to run it. Increase the time by 5 minutes each day until I get a reaction. Then I back off 5 minutes and skip a day. Then slowly increase the time until I get a reaction and back off 5 minutes and run it for a few days and then start increasing the time. I want to kill the cancer as fast as the body can get rid of the toxins, but not so fast that I make myself sicker.
  5. I press "113" then press "Run" I Keep the Plasma as close to the cancer as I can. I drink a lot of water.

How I set up for Detox.

  1. I set the GB4000 for "Audio" and "Square Wave" (Carrier to 31000000).
  2. I take two charcoal capsules to bind and remove the toxins.
  3. I press "30" (G2- this will run 1 hour).
  4. I then press "Auto Channel" "206"
  5. I then press "Run"
  6. I adjust the power knob on the GB4000 until the milliamp meter on the MOPA reads about 200.
| Home | Contact Me | Video Interview | My Prostate Cancer | My Bone Cancer | My Daily Schedule | My VA Test Reports | Links to Other Sites |
© copyright 2019 John Hackett, www.gb4000.to All Rights Reserved.
*DISCLAIMER*: Results may vary from person to person. The information contained in this Website is provided for general informational purposes only. It is not intended as and should not be relied upon as medical advice. The information may not apply to you and before you use any of the information provided in the site, you should contact your qualified medical provider or another appropriate professional.
You should assume unless specifically stated otherwise that the owner of this website may be compensated for purchases or services mentioned on this website. Where names have been used on this website, these should be considered as pen names of real people which have been changed to protect privacy unless otherwise stated. All images displayed on this website should be considered as stock photos used for illustration purposes and to protect privacy unless stated otherwise.